The Tri-Slot Plasma Stencils will guide your hand held plasma cutter to quickly and accurately cut a perfect slot. These stencils are offset to precisely cut the size indicated. Bolts will fit fairly tight in slots after plasma cutting and can then be loosened up by squaring up the plasma cut edge. Each kit includes 3 stencils for 9 sizes: slot lengths are 2, 4, or 6 bolt lengths. In addition to center lines, the end of each slot is also etched onto the stencils. Available for most plasma cutters that have a drag shield attachment. Laser cut and etched from 11ga. cold rolled steel. The end result is a quick, clean and accurate cut that can be done anywhere. Made in the USA.
3/8" slot lengths are ¾", 1 ½", 2 ¼" 1/2" slot lengths are 1", 2", 3" 5/8" slot lengths are 1 ¼", 2 ½", 3 ¾"
-Designed for use with a drag shield attachment- diameter should be within .010" for proper cutting
-Hypertherm - .380" dia. (some Hypertherm models are .430" dia.)
-Miller - .430" dia. (some Eastwood, Hobart and Lincoln models are this size)
-Thermal Dynamics - .580" dia. (will not work with cutmaster 42)Quick and accurate slot cutting
Laser etched sizes, centerline marks and end of slot
Offset to cut a tight fitting slot
Includes 3 stencils for 9 sizes: slot lengths are 2, 4, or 6 bolt lengths
Comments
Post a Comment